Removal and installation of the radio receiver (Range Rover 3)

Removing

1. Remove the hatch located in a luggage carrier on the left side.

2. Remove the cover of the box located in the trunk on the left side.

3. Raise and secure the spare wheel cover.



4. Remove the hexagon head bolts for attaching the luggage securing rings.

5. Turn away 2 screw couplers of fastening of the left back panel of a luggage space.

6. Carefully release and remove the panel.



7. Turn away the bottom screw coupler of fastening of the forward panel of a luggage space.

8. Remove the rivet securing the left luggage compartment panel to the box.

9. Remove the 3 nuts securing the drawer, carefully loosen and remove the drawer.



10. Disconnect the block from the radio.


11. Disconnect the coaxial cable.

12. Turn away 2 nuts of fastening of a clamp of a radio receiver and remove a clamp.

13. Remove the radio.

Installation

1. Install the radio, reinstall the retainer and tighten the nuts with a torque of 6 Nm.

2. Connect the coaxial cable.

3. Attach the wiring block.

4. Install the box and secure it with nuts.

5. Install the panel rivet.

6. Install the turnbuckles.

7. Install the rear left panel, align with the tailgate seal and install the tie rods.

8. Fit the load securing rings and tighten the hex socket head bolts to 25 Nm.

9. Lower and secure the spare wheel cover.

10. Install the drawer lid.

11. Replace the hatch.