Car steering Range Rover 3

Power steering air removal
Checking the fluid level 1. Clean the area around the power steering reservoir cap and level marks from dirt. 2. Check the condition of the working fluid. If there are air bubbles, wait until they...

Checking and adjusting the angles of the front wheels
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Wheel alignment
A change in the camber angle entails a change in other angles, so the adjustment should be started from the camber angle. Before disconnecting the battery, make sure that all the requirements and...

Checking the pressure in the hydraulic system TD6
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Checking the pressure in the hydraulic system V8
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Steering rack with power steering TD6 (left-hand drive)
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Steering rack with power steering V8 (left-hand drive)
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Steering rack with gur v8 (right-hand drive)
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Steering rack with power steering TD6 (right-hand drive)
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Fluid cooler TD6
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Fluid cooler V8
Dismantling 1. Disconnect the negative plug from the storage battery. 2. Remove a forward facing of a radiator. EXTERIOR PARTS, REPAIR WORKS, Radiator grille. 3. Remove the heatsink assembly. COOLING...

Power steering pump TD6
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Power Steering Pump V8
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Steering column assembly
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Steering Angle Sensor / Steering Column
Dismantling 1. Remove the steering column assembly. STEERING, REPAIR WORKS, Steering column assembly - inner and outer parts. 2. Separate the steering angle sensor from the retainer holding it and...

The top overlays of a steering column assembled with a column
Dismantling 1. Pull the steering column fully out for easy access. 2. Turn out 3 screws - a self-tapping screw of fastening of the top overlays of a steering column. 3. Release the pads from the...

Multifunction control lever
Dismantling 1. Remove the current collector assembly. RETAINING SYSTEMS FOR DRIVER AND PASSENGERS, REPAIR WORK, Rotary Current Collector. 2. Release the latch securing the multifunction control lever...

Tie Rod Ball Joint
Dismantling 1. Raise the front of the car. WARNING: Do not work under a vehicle raised only on a jack or lift. Always install safety props. 2. Remove the front wheel. 3. Loosen the locknut that...

Steering wheel
Dismantling 1. Remove the airbag module from the steering wheel. RESTRAINT SYSTEMS FOR DRIVER AND PASSENGERS, REPAIR WORK, Airbag module - steering wheel. 2. On models with electrically heated...

Steering wheel airbag control unit
Before disconnecting the battery, make sure that all the requirements and conditions contained in the section on disconnecting the battery are met. GENERAL INFORMATION, Precautions when working with...

Electronic control unit (ECU) of the steering wheel with electric heating
If the ECM needs to be replaced, connect the Testbook/T4 and follow the correct sequence before disconnecting the battery. Before disconnecting the battery, make sure that all the requirements and...