Deployment of the rear curtain airbag outside the vehicle (Range Rover 3)

This manual is intended to assist authorized service personnel in the safe disposal of airbag modules.

Airbag Deployment

WARNING: Before working on passive safety systems, carefully read the relevant technical documentation.

1. Follow all safety rules when working with passive safety systems.

GENERAL INFORMATION, Safety Precautions When Working on the Airbag System (SRS).

2. Remove the airbag from the vehicle.

RESTRAINT SYSTEMS FOR DRIVER AND PASSENGERS, REPAIRS, Airbag Module (rear curtain airbag).

3. Check the condition of the LRT-86-003 fixture and cables supplied with it.



4. Clamp the bracket LRT-86-007/02 in a vise. The vise should clamp the bracket above the bottom flange to prevent the bracket from moving upwards due to detonation. Tighten the vise.



5. Install two brackets LRT-86-007/05 on the bracket LRT-86-007/02 and fix them with bolts.


6. Install the airbag on the brackets LRT-86-007/05 and secure it.



7. Connect the cable LRT-86-003/08 of the accessory to the airbag.

8. Attach the LRT-86-003 tool to the end of the LRT-86-003/08 cable.

9. Attach tool LRT-86-003 to battery.

WARNING: Ensure that all persons are at least 15 m away from the air bag module.

10. To bring the airbag into action, press the power button on the fixture body.

11. Disconnect the tool from the battery.

WARNING: When deployed, parts of the airbag become hot and may cause burns. Wait 30 minutes after deployment before touching the airbag module.

12. Disconnect the accessory cable from the airbag.

13. Remove the airbag module from the bracket and place in a sealed bag for later disposal.

14. Wipe the bracket with a damp cloth and remove from the vise.

15. Dispose of the spent air bag module to a designated incineration area.

WARNING: It is forbidden to reuse any parts of the passive safety systems.

NOTE: Do not transport parts of deployed restraint systems in the vehicle interior.