Applying sealant to the wheel arch and side panel of the body (Range Rover 3)
Welding seams located symmetrically as shown in the figure are also subject to processing. Apply a bead of mastic with a diameter of 3 mm to all marked panel joints. Do not block the drain holes in the threshold with mastic.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Previous articles
Current article
Applying sealant to the wheel arch and side panel of the body
Next articles
Applying sealant to the inside of the side panel
Acoustic insulation with foam material
Sealing the front seams
Sealing the rear seams
Sealing the welding seams of the lower part of the car
Sealing door welds
Sealing and underbody materials
Treatment of closed cavities for injection of the composition
Sealants for filling cavities
Water intrusion into the body
Preparing the panel for primer
Preparation for painting
Acoustic insulation with foam material
Sealing the front seams
Sealing the rear seams
Sealing the welding seams of the lower part of the car
Sealing door welds
Sealing and underbody materials
Treatment of closed cavities for injection of the composition
Sealants for filling cavities
Water intrusion into the body
Preparing the panel for primer
Preparation for painting
Similar articles from Land Rover repair manuals:
• Rear side inner panel and wheel arch Freelander 2 (2006-2014)
• Reinforcement of the outer panel of the wheel arch Freelander 1 (1997-2006)
• Trim panel of the rear side of the body Discovery 3 (2004-2009)
• Trim panel of the rear side of the body Defender 2007+ (2007-2016)
• Rear side inner panel and wheel arch Freelander 2 (2006-2014)
• Reinforcement of the outer panel of the wheel arch Freelander 1 (1997-2006)
• Trim panel of the rear side of the body Discovery 3 (2004-2009)
• Trim panel of the rear side of the body Defender 2007+ (2007-2016)
No comments yet
Comments on this article