Car Body Corrosion Protection Range Rover 3

Types of hermetic connections
1. Between panels - bolted connection 2. Between the edges of the panels - bolted connection 3. Between panels - spot welding connection 4. Between the edges of the panels - spot welding connection...

Body sealing materials

Equipment for applying sealants and primers
Suitable sealer and primer application equipment is available from the following manufacturers and suppliers: 3M Automotive Trades Group 3M UK Plc 3M House PO Box 1 Market Place Bracknell Berks RG12...

Body cavity treatment equipment and treatment methods
1. Air inlet 2. Spray pattern adjustment 3. Tank (1 liter capacity). Maximum pressure 9.7 bar (9.84 kg/sq.cm) 4. Gun nozzle 5. Nozzle fitting 6. Flexible tip 7. Hard tip with narrow cone nozzle 8....

Applying sealant to the front side members
Welding seams located symmetrically as shown in the figure are also subject to processing.

Applying sealant to the wheel arch and side panel of the body
Welding seams located symmetrically as shown in the figure are also subject to processing. Apply a bead of mastic with a diameter of 3 mm to all marked panel joints. Do not block the drain holes in...

Applying sealant to the inside of the side panel
Welding seams located symmetrically as shown in the figure are also subject to processing. Apply a bead of mastic with a diameter of 3mm to all marked panel joints. Do not block the drain holes in...

Acoustic insulation with foam material
Expandable foam materials, numbered 1 to 10, are applied to various areas of the body, into closed cavities and to the interior of the side panel of the body. Foaming seals number 11 and 12 are...

Sealing the front seams
Welding seams located symmetrically as shown in the figure are also subject to processing. When processing front suspension strut columns, the mounting holes for attaching the shock absorber strut...

Sealing the rear seams
Welding seams located symmetrically as shown in the figure are also subject to processing.

Sealing the welding seams of the lower part of the car
Welding seams located symmetrically as shown in the figure are also subject to processing. The drain holes at the bottom of the doors must not be blocked by sealing material.

Sealing door welds
Welding seams located symmetrically as shown in the figure are also subject to processing.

Sealing and underbody materials
Underbody sealing materials The surface of the bottom and the outer surfaces of the thresholds are treated with a bottom sealant Plastisol PVC. This material is not suitable for reapplication. During...

Treatment of closed cavities for injection of the composition
Front body The arrows show the injection sites of the composition. Welding seams located symmetrically as shown in the figure are also subject to processing. Front fender The arrows show the...

Sealants for filling cavities
After repair work, always treat the repaired cavities with a protective compound. In addition, the cavities that were affected during the repair should also be treated, regardless of whether they...

Water intrusion into the body
When water enters the body, always use a logical approach to the problem of fixing a leak, using experience, knowledge and intuition. You can't make a decision based on what you see, like when you...

Preparing the panel for primer
General information Replacement body parts have an initial cathophoresis primer coating as part of the panel protection that complies with the general warranty against body corrosion. DO NOT remove...

Preparation for painting
To restore the paintwork, use the following operations: 1. Treat the outer and inner surfaces of the weld with the recommended protective coating. 2. Repair the damaged underbody seal. Adhesive...