Vehicle ignition system Land Rover Freelander 2

Engine Ignition Specifications
General specification Position Specification Spark plug : Vehicles up to VIN 7H038589 Model NGK Type LPR6D Gap 0.6 mm (unregulated) Cars after VIN 7H038589 Model NGK Type ILRF6B Gap 0.75mm±0.05mm...

Description and principle of operation of the ignition system
Pos. spare part no Name 1 - Ignition coil 2 - Spark plug 3 - Engine control module (ECM) The ignition system of the 3.2L Si6 engine has one iridium-tipped spark plug per cylinder, with each spark...

Ignition control circuit
NOTE: A = Wired connection; D= High speed CAN bus Pos. spare part no Name 1 - Battery 2 - CAN bus to other vehicle systems 3 - Dashboard 4 - Electronic steering column lock 5 - ECM 6 - Ignition coil...

Inspection and testing of the ignition system
CAUTION: Diagnosis by substituting a component from another vehicle is NOT allowed. The substitution of control units does not guarantee confirmation of the fault and, moreover, may cause additional...

Table of fault signs
Symptom Possible reason Action Engine cranks but won't start Disconnecting / reducing the capacity of the engine ventilation system Engine ignition system Fuel system Electronic engine controls Check...

DTC Fault Code Index
NOTE: If a control module or one of the components is suspected and the vehicle is still under manufacturer's warranty, refer to the warranty manual before installing a new module/component (section...

Ignition coil in block with spark plug
Removing 1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications). CAUTION: After turning off the...

Spark plug
Removing 1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications). CAUTION: After turning off the...

Glow plug system
Torque Specifications Description Nm lb-ft glow plugs 10 7 Description and principle of operation Pos. spare part no Name 1 - glow plugs 2 - Control lamp for glow plugs 3 - BJB Glow plugs are...

Glow plug control circuit
NOTE: A = permanent wired connection Pos. spare part no Name 1 - Battery 2 - Start/stop switch and control module 3 - ECM 4 - glow plugs 5 - BJB

Inspection and testing of glow plugs
CAUTION: Diagnosis by substituting a component from another vehicle is NOT allowed. Substitution of control modules does not guarantee confirmation of the fault and, in addition, may cause additional...

Glow plug DTC indicator
NOTE: If a control module or component is suspected and the vehicle continues to be covered by the manufacturer's warranty, refer to the warranty manual before installing a new module/component...

Preheating candles
CAUTION: These items must be handled with the utmost cleanliness. NOTE: TD4 engine cylinders are numbered from the rear of the engine (from the back of the gearbox). Therefore, cylinder number 1 and...