Vehicle exhaust system Land Rover Freelander 2

Exhaust System Specification
Lubricants, fluids, sealants and adhesives Detail Specifications Removing the oxygen sensor (H02S) * WD40 or equivalent Oxygen sensor thread (H02S) Apply appropriate amount of heat-resistant...

Description and principle of operation
With particulate filter Pos. spare part no Name 1 - An exhaust manifold (for reference only) 2 - Differential pressure sensor 3 - Heated oxygen sensor (HO2S) (for reference only) 4 - catalytic...

Filter of solid products of diesel fuel combustion
Diesel Particulate Filter System (DPF) reduces emissions of particulate products of combustion of diesel fuel to negligible levels. Pos. spare part no Name 1 - temperature sensor 2 - HO2S 3 -...

Diesel Combustion Filter
The DPF is located in the exhaust system, behind the catalytic converter. The main characteristic of the DPF is its ability to regenerate. Regeneration is the combustion of solid particles trapped in...

Flue gas filter control system
To achieve optimal DPF performance and prevent clogging, the condition of the DPF must be constantly monitored. The ECM contains DPF software that manages the monitoring and operation of the DPF...

Differential pressure and temperature sensor DPF
Pos. spare part no Name 1 - High pressure connection 2 - Low pressure connection 3 - electrical connector The differential pressure sensor is located in the engine compartment on the lower right side...

Indication on the instrument panel
If the vehicle regularly makes short trips at low speed, effective DPF regeneration may not be possible. In this case, the DPF software determines that the DPF is clogged based on signals from the...

Side effects of the combustion products filter
The following section describes some of the side effects caused by the active regeneration process. Engine oil dilution Dilution of the engine oil can occur due to a small amount of fuel entering the...

Catalytic converter (without fuel filter)
Special tool 310-121 Wrench, H02S Removing 1. Raise the car on a lift. 2. 3. 4. 5. Remove the front mudguard. Refer to procedure: Motor protection (501-02 Front body panels, Removal and...

Catalytic converter (with fuel filter)
Special tool 310-121 Wrench, H02S Removing 1. Raise the car on a lift. WARNING: Place secure stands under the vehicle. 2. Remove the engine cover. Refer to Procedure: Engine Cover - 2.2L Duratorq -...

Exhaust gas exhaust system
WARNING: Use caution when working near hot exhaust system components. NOTE: The description of the removal procedure in this manual may include installation steps. Removing All vehicles 1. Raise and...

Diesel particulate filter
WARNING: Use caution when working near hot exhaust system components. Removing 1. Raise the car on a lift. 2. Remove the lower engine shield. Refer to procedure: Motor protection (501-02 Front body...

Diesel particulate filter differential pressure sensor
WARNING: Use caution when working near hot exhaust system components. NOTE: The description of the removal procedure may contain a description of the installation steps. 1. Raise and support the...