Engine bottom insulator (Freelander 2)

NOTE: The description of the removal procedure may contain a description of the installation steps.

Removing

1. Raise the vehicle.

WARNING: Place secure stands under the vehicle.

2. Remove the motor protection. Refer to procedure: Motor protection (501-02 Front body panels, Removal and installation).

3. Remove the bottom support pad. Tightening torque: 110 Nm

CAUTION: Make sure that the elements are installed in the original position marked during removal.

Petrol vehicles

4. Remove the heat shield. Tightening torque: 10 Nm

NOTE: Do not proceed with further dismantling if the element is removed only for access.

All vehicles

5. Remove the engine mount brackets. Tightening torque: 110 Nm

Installation

Install the elements in place, working in reverse order.