NOTE: The description of the removal procedure may contain a description of the installation steps.
Removing
1. Remove the cover and disconnect the ground wire from the battery. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Remove the collection chamber panel. Refer to Procedure: Mixing Chamber (412-01 Climate control, Removal and installation).
3.
4. Shown is the ECM for a gasoline engine, similar for a diesel engine.
5. Tightening torque: 6 Nm
Installation
All vehicles
1. When installing, follow the removal procedure in reverse order.
Vehicles with diesel flue gas filter (DPF)
2. Change engine oil and filter. Refer to Procedure: Draining and Refilling Engine Oil (303-01B Engine - 2.2L Duratorq - Td4, General procedures).
All vehicles
3. If a new item was installed, configure using Land Rover approved diagnostic equipment.
Comments on this article