Parking assistance Land Rover Freelander 2

Parking assistance specification
Detail Specifications Definition (behind) : Central sensors 1800 mm (70,9 in) Side sensors 600 mm (23,6 in) continuous signal 300 mm (11,8 in) Definition (front) : Central sensors 800 mm (31,5 in)...

Description and principle of operation
Pos. spare part no Name 1 - Parking Assist Module 2 - Front and rear speaker 3 - Front Parking Assist Sensor (4 things.) 4 - Parking Assist Switch 5 - Integrated control module (ICM) 6 - Amplifier 7...

Parking Assist Module
The parking assist control module is located on the left side of the luggage compartment, behind the pillar trim panel "WITH". The parking assist module has three connectors that provide power,...

Parking assistance sensors
Four ultrasonic sensors are located in the front and rear bumpers. Each sensor contains the sensor itself and a bumper insert. The insert ensures the correct orientation of each sensor relative to...

Parking Assist Switch
Pos. spare part no Name 1 - Parking Assist Switch The park assist switch is located in the instrument panel switch box, above the touch screen. This is a left switch with a built-in LED. The park...

Parking assistant control scheme
NOTE: A = Permanent wired connection; N = Medium speed CAN bus; P = Fiber optic MOST bus Pos. spare part no Name 1 - Battery 2 - Electrical distribution box 3 - Auxiliary electrical box 4 - Central...

How the parking assistant works
When the parking aid module activates the system to indicate that the system is operating, the switch LED turns on and a single beep is emitted from the front and rear speakers. The parking...

Inspection and verification
CAUTION: Diagnosis by substituting a component from another vehicle is NOT allowed. Substitution of control modules does not guarantee confirmation of the fault and, in addition, may cause additional...

DTC Fault Code Index
NOTE: If a control module is suspected and the vehicle continues to be covered by the manufacturer's warranty, refer to the warranty manual before installing a new module (subsection B1.2), or...

Front interior parking aid sensor
Removing 1. Raise and support the vehicle. WARNING: Do not work on or under a vehicle supported only by a jack. Always place secure supports under the vehicle. 2. Remove the front wheels. Refer to...

Front Outside Parking Assist Sensor
NOTE: Removal of the rightmost front parking assist sensor requires removal of the front bumper fascia. Removing 1. Raise and support the vehicle. WARNING: Do not work on or under a vehicle supported...

Removing and installing the system module
Removing 1. Remove the panel of furnish of the left back lateral part of a body. Refer to Procedure: Rear Side Trim Panel (501-05 Interior trim, Removal and installation). 2. Remove the parking aid...

Rear interior parking aid sensor
Removing 1. Raise and support the vehicle. WARNING: Place secure stands under the vehicle. Installation 1. When installing, repeat the removal procedure in reverse order. CAUTION: If a new sensor is...

Rear Outside Parking Assist Sensor
Removing 1. Raise and support the vehicle. WARNING: Place secure stands under the vehicle. 2. Release the wing mudguard. 3. Installation 1. Install the elements in the reverse order of disassembly....