Front Door Module (FDM) (Freelander 2)

Removing

1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).

2. Remove the front door trim panel. Refer to Procedure: Rear Door Trim Panel (501-05 Interior trim, Removal and installation).

Installation

1. When installing, follow the removal procedure in reverse order.

2. Connect a wire of weight to the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).

3. If a new item was installed, configure using Land Rover approved diagnostic equipment.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Element layout — LIN bus
Element Location — Medium Speed CAN Bus
Element Location — High Speed CAN Bus
Element Location — MOST
Overview of control modules
Inspection and verification
DTC Fault Code Index

Current article

Front Door Module (FDM)

Rear Door Module (RDM)
Driver Seat Module (DSM)

Similar articles from Land Rover repair manuals:
• Front door speaker Discovery 3 (2004-2009)
• Front Door Airbag Module Range Rover 3 (2001-2012)
• Front door trim panel Defender 2007+ (2007-2016)

Comments on this article

No comments yet

Freelander 2

Freelander 1