Driver Seat Module (DSM) (Freelander 2)

NOTE: The description of the removal procedure in this manual may include installation steps.

Removing

1. Remove the cover and disconnect the ground wire from the battery. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).

2. Tightening torque: 7 Nm

Installation

1. Replace the elements in reverse order.

2. Using the approved Land Rover diagnostic system, calibrate the new module.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Element layout — LIN bus
Element Location — Medium Speed CAN Bus
Element Location — High Speed CAN Bus
Element Location — MOST
Overview of control modules
Inspection and verification
DTC Fault Code Index
Front Door Module (FDM)
Rear Door Module (RDM)

Current article

Driver Seat Module (DSM)

Comments on this article

No comments yet

Freelander 2

Freelander 1