Removal and installation of the antenna of the audio system (Freelander 2)

NOTE: The description of the removal procedure may contain a description of the installation steps.

Removing

1. Remove the upper tailgate trim panel. Refer to Procedure: Tailgate Trim Panel (501-05 Interior trim, Removal and installation).

2. Remove the audio unit's antenna. Tightening torque: 10 Nm

Installation

1. When installing, follow the removal procedure in reverse order.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Inspection and verification
Table of signs of malfunctions of the navigation system
DTC Fault Code Index
Pinpoint tests
Navigation system troubleshooting tests
Bolt tightening torques
Description and principle of operation
Low Series Audio System
High Series Audio System
AM/FM tuner
CD player
Additional power socket
Rear seat headphone modules
Controls located on the steering wheel
SDARS (North America only)
High definition radio (North America only)
Master system clock
Power Amplifiers
Control scheme
Speaker Location
Speaker control circuit (basic level)
Speaker control circuit (mid level)
Speaker control circuit (high level)
Mobile phone description
Mobile phone control scheme
Navigation system
Navigation system control scheme
How the navigation system works
Removing and installing the audio block
Speaker in the front door
Speaker in rear door
Removing and installing the video system display

Current article

Removal and installation of the antenna of the audio system

Satellite radio receiver
Removing and installing a cell phone antenna
Low-frequency speaker amplifier
Removal and installation of the subwoofer
Controls of the audio system in the back seat
Bluetooth module
Navigation system that works with DVDs
Description and principle of operation of the antenna
Antenna control circuit

Comments on this article

No comments yet

Freelander 2

Freelander 1