Satellite radio receiver (Freelander 2)

NOTE: The description of the removal procedure may contain a description of the installation steps.

Removing

1. Remove the panel of furnish of the left back lateral part of a body. Refer to Procedure: Rear Side Trim Panel (501-05 Interior trim, Removal and installation).



3. Tightening torque: 10 Nm

Make sure that fiber optic cables do not bend with a radius of less than 25 mm. Clean the optical connectors of foreign material.

4. Tightening torque: M5 6 Nm. M6 10 Nm

NOTE: Do not proceed with further disassembly if the element is removed only for access.

Installation

1. When installing, follow the removal procedure in reverse order.

2. If a new item is to be installed, configure using Land Rover approved diagnostic equipment.