DTC Fault Code Index (Freelander 2)

For the various PATS modes/faults listed in the table, the CJB logs a DTC that is not displayed to the customer.

When you enter the key, turn on the ignition (ON state) and receiving permission to start, the LED in the lower left part of the instrument panel will light up for 3 seconds, after which it will turn off. If permission to start is not obtained, the LED will flash 1 time every 2 seconds. The table below lists the fault codes that are logged under certain conditions. For more information.

For more information refer to: Starting system (303-06A Starting system - 3.2L NA - I6, Diagnostics and checks) Electronic controls (303-14A Electronic controls - 3.2L NA - I6, Diagnostics and checks) Electronic controls (303-14B Electronic Controls - 2.2L Duratorq - Td4, Diagnostics and Tests).

Operating mode/Fault	Registration conditions	Ignition status	DTC	Indication
Examination	Missing	Switching from OFF to ON	Missing	LED on for 3 seconds
SCU Internal Fault	key introduction	Any	B102496	Warning message display
Lost Communication with SCU (SCU not responding)	key introduction	Any	B102487	Warning message display
Wrong SCU response	key introduction	Any	B102481	Warning message display
SCU not programmed	key introduction	Any	B102451	Warning message display
The dongle is not responding	key introduction	Any	B102408	Warning message display
Invalid transceiver response	key introduction	Any	B102581	Warning message display
Communication error with TP	key introduction	Any	B102408	Warning message display
The number of programmed keys is less than the minimum	Manufacturer/Dealer	Any	B10D800	No indication
Key not programmed	Manufacturer/Dealer	Any	B10D751	No indication
SCL not programmed	Manufacturer/Dealer	Switching from OFF to ON	B102651	Warning message display
Lost communication with ECM	Missing	Any	U010000	Warning message display