NOTE: The steps in this procedure may be part of the installation procedure.
Removing
1. Disconnect the battery ground wire. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Raise and support the vehicle.
WARNING: Place axle stands under the vehicle.
3. Remove the fuel-fired auxiliary heater. Refer to Procedure: Fuel Auxiliary Heater (412-02 Additional climate control, Removal and installation).
4. Tightening torque: 10 Nm
![](https://www.lrman.ru/img/freel/1660.jpg)
5.
![](https://www.lrman.ru/img/freel/1661.jpg)
6.
![](https://www.lrman.ru/img/freel/1662.jpg)
7. Tightening torque: 7.5 Nm
![](https://www.lrman.ru/img/freel/1663.jpg)
8. Tightening torque: 10 Nm
![](https://www.lrman.ru/img/freel/1664.jpg)
9.
![](https://www.lrman.ru/img/freel/1665.jpg)
10.
![](https://www.lrman.ru/img/freel/1666.jpg)
11.
![](https://www.lrman.ru/img/freel/1667.jpg)
12.
![](https://www.lrman.ru/img/freel/1668.jpg)
13. Tightening torque: 7 Nm
NOTE: Remove and discard gasket.
![](https://www.lrman.ru/img/freel/1669.jpg)
Installation
1. Install the elements in the reverse order of disassembly.
Comments on this article