NOTE: The description of the removal procedure in this manual may include installation steps.
1. Disconnect the battery ground wire. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Raise and support the vehicle.
WARNING: Place secure stands under the vehicle.
3. Drain the coolant. Refer to Procedure: Drain/Fill Coolant and Bleed Cooling System (303-03B Engine Cooling - 2.2L Duratorq - Td4, General Procedures).
4. Remove the mudguard of the right wing. Refer to Procedure: Fender Mudguard (501-02 Front body panels, Removal and installation).
5. Tightening torque: 10 Nm
![](https://www.lrman.ru/img/freel/1651.jpg)
6.
- Substitute a container to collect the escaping liquid
- Disconnect the two coolant hoses
- Disconnect the fuel line
Possible fluid leakage. Plug all openings. Install new plugs.
![](https://www.lrman.ru/img/freel/1652.jpg)
7. Tightening torque: 10 Nm
![](https://www.lrman.ru/img/freel/1653.jpg)
8. Remove the fuel-fired auxiliary heater.
![](https://www.lrman.ru/img/freel/1654.jpg)
Installation
1. Reinstall the elements, working in reverse order.
Comments on this article