Power Steering Reservoir (Freelander 2)

Removing

1. Remove the power steering reservoir cap.

2. Using a suitable syringe, remove the working fluid from the power steering reservoir.

3. Remove the power steering reservoir.

Prepare to collect spilled liquid. Plug all openings. Use new plugs.

Installation

1. When installing, follow the removal procedure in reverse order.

2. Fill the power steering system with fluid and bleed air from the system. Refer to Procedure: Bleeding Power Steering System (211-00 Steering system - General information, General procedures).

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Steering specification
Inspection and verification
Table of fault signs
Bleeding air from the power steering system
Flushing the power steering system
Power Steering Specification
Description of power steering
Steering Gear Description
Steering Valve Block Description
Power Steering Pump Description
Description of the steering fluid reservoir
Fluid cooler (i6 only)
The principle of operation of the hydraulic booster
Checking the pressure in the hydraulic booster circuit 2.2L Duratorq — TD4
Power Steering Pump 2.2L Duratorq — Td4
Removal and installation of the steering mechanism
Power Steering Working Fluid Cooler

Current article

Power Steering Reservoir

Description and principle of operation of the steering gear
Thrust tip
Steering gear cover

Comments on this article

No comments yet

Freelander 2

Freelander 1