Car front suspension Land Rover Freelander 2

Front Suspension Specifications
Detail Specifications front of the car Conventional coil spring with double-tube shock absorber and reinforced anti-roll bar Spring identification Spare part number Specifications Insulator LR 001131...

Description and principle of operation of the front suspension
Location of elements Pos. spare part no Name 1 - Right (RH) spring and damper assembly 2 - stabilizer bar 3 - The bar of the stabilizer bar 4 - Left (LH) spring and damper assembly 5 - wheel fist 6 -...

Front wheel bearing
Special tool 204-348/3 Remover/Installer, Wheel Hub/Wheel Bearing 204-348-01 Adapter for 204-348 204-528/1 Remover/Installer, Bushing 204-536/2 Remover/Installer, Bushing 205-802/5 Remover, Wheel...

Lower arm
Special tool 204-619 G-Clamp 205-857 Remover, Halfshaft 211-316 Separator, Ball Joint Removing 1. Remove the mixing chamber panel. Refer to Procedure: Mixing Chamber (412-01 Climate control, Removal...

Front stabilizer bar
Removing CAUTION: Nuts and bolts must be tightened with the vehicle supported on the suspension. NOTE: Use only clean water to lubricate the bushing if necessary. NOTE: The description of the removal...

Front stabilizer bushing
Removing 1. Raise and support the vehicle. WARNING: Place secure stands under the vehicle. 2. Remove the front wheels complete with tires. Refer to procedure: Wheel and tire (204-04 Wheels and tires,...

Front stabilizer bar
Removing 1. Raise and support the vehicle. WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Always place secure supports under the vehicle. 2. Remove the front wheel....

Front wheel knuckle
Special tool 204-159 Lever, Wheel Knuckle 204-619 G-Clamp 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft 211-316 Separator, Ball Joint Removing NOTE: The description of the removal...

Front shock absorber
Removing Verify that the SWL spring compressor is sized to match or exceed the spring rate given in the Specifications section. Always follow the manufacturer's instructions for use for the spring...

Shock absorber with spring
Special tool 204-159 Lever, Wheel Knuckle 204-619 G-Clamp Removing 1. Remove the mixing chamber panel. Refer to Procedure: Mixing Chamber (412-01 Climate control, Removal and installation). 2....

Spring
Removing Verify that the SWL spring compressor is sized to match or exceed the spring rate given in the Specifications section. Always follow the manufacturer's instructions for use for the spring...