Car sunroof Land Rover Freelander 2

Torque Specifications
Description Nm lb-ft Sunroof Motor Torx Cap 5 4 Sunroof Alignment Torx Head Screws 3 2 Sunroof bolts 3 2 Roof panel motor tether 4 4

Description and principle of operation
Pos. spare part no Name 1 - Switch 2 - Control unit/motor 3 - Sunroof panel 4 - Central electrical box (CJB) The sunroof panel is a double-length block of glass, with the rear half fixed in place....

Control unit and electric motor
Pos. spare part no Name 1 - electric motor 2 - Control block The control unit, combined with the electric motor, is installed behind the headlining at the rear of the sunroof panel. The control unit...

Sunroof panel
Pos. spare part no Name 1 - Drain hose (2 pcs.) 2 - Twisted cable (2 pcs.) The sunroof panel is attached to the outside of the body side panels. Polyurethane adhesive is used to fasten the front roof...

Control Chart
NOTE: A = rigid connection; D = high speed CAN bus Pos. spare part no Name 1 - Battery 2 - Switch 3 - Control unit/motor 4 - Anti-Lock Braking System Control Module (ABS) 5 - CJB 6 - Battery junction...

Work principles
The sunroof panel only works when the vehicle is in power mode 6 (ignition). The sunroof panel control/motor is powered by the CJB, which supplies both continuous battery power and ignition power....

Sunroof Panel Symptoms Table
sign Possible reason Action Opening sunroof panel - noise during operation Noise is heard during operation of the opening sunroof panel Displaced or damaged side acoustic seals Displaced or damaged...

Inspection and verification
CAUTION: Diagnosis by substituting a component from another vehicle is NOT allowed. Substitution of control modules does not guarantee confirmation of the fault and, in addition, may cause additional...

DTC Fault Code Index
NOTE: If a control module or component is suspected and the vehicle continues to be covered by the manufacturer's warranty, refer to the warranty manual before installing a new module/component...

Diagnostic localization of a sunroof malfunction
Pinpoint test A: opening sunroof panel - noise during operation A1: electric motor - noise during operation NOTE: These tests are performed to determine the cause of the noise during operation of the...

Sunroof blind winding procedure (up to VIN 154971)
1. Close the blind of the sunroof opening panel (but do not fix the handle on the frame). 2. Disconnect the blind of the sunroof opening panel from the rails. Rotate the left corner counterclockwise...

Sunroof blind winding procedure (from VIN 154972)
1. Close the blind of the sunroof opening panel. 2. Disconnect the blind of the sunroof opening panel from the rails. Rotate the left corner counterclockwise and release the right corner from the...

Motor programming
1. Set the ignition to position «ON» (On). With the sunroof closed, press and hold the front of the switch until the sunroof moves to the raised position. Release the sunroof switch. 2. Press the...

Removal and installation of the hatch of a cover
Protect surrounding paintwork to avoid damage. Protect the surrounding finish to avoid damage. Removing 1. Remove the rear section of the roof molding. Remove two clamps. Working from the rear end,...

Sunroof glass
Removing 1. Apply strips of masking tape to the front edge of the fixed rear window to prevent damage when the window is raised. NOTE: Left side shown, right side similar. 2 Disable work mode "one...

Electric motor of the sunroof drive
NOTE: The sunroof panel motor can be accessed by partially releasing the headlining. The electric motor is located above the rear interior lamp. Removing 1. Remove a rear-view mirror of salon. Refer...

Air deflector
Removing 1. Open the sunroof. 2. Remove a rear-view mirror of salon. Refer to Procedure: Interior Rear View Mirror (501-09 Rear-view mirrors, Removal and installation). 3. Remove trim panels on both...

Sun panel for transparent roof
Removing 1. Remove trim panels from both pillars "A". Refer to Procedure: Rack Trim Panel (501-05 Interior trim, Removal and installation). 2. Remove the upper trim panels of both pillars "IN". Refer...

Sunroof coating sunroof cover
Removing 1. Remove trim panels from both pillars "A". Refer to Procedure: Rack Trim Panel (501-05 Interior trim, Removal and installation). 2. Remove the upper trim panels of both pillars "IN". Refer...