Car rear view mirrors Land Rover Freelander 2

Description and principle of operation
NOTE: Left hand drive option shown (LHD); right hand drive variant (RHD) similar. Pos. spare part no Name 1 - Interior mirror with manual dimming function 2 - Interior rear-view mirror with...

Interior rearview mirror
Pos. spare part no Name A - Manual dimming mirror B - Auto dimming mirror 1 - Mirror bracket cover (2 parts) 2 - Back-facing light sensor 3 - Forward facing light sensor 4 - Interior humidity sensor...

Exterior mirrors
Powered and heated exterior mirrors are standard. Depending on the specification and trim level of the vehicle, the following options are available: Folding by means of the electric drive (function...

Adjustment of external rear-view mirrors
Pos. spare part no Name 1 - Left exterior mirror selection switch 2 - 4 way joystick 3 - Right exterior mirror selection switch The door mirrors are controlled by a switch block located on the...

Power folding mirror function
Power folding/auto folding mirrors have an additional electric motor located in the hinge of each outside rearview mirror arm. The operation of the folding door mirrors is controlled by the switch...

Heated exterior mirrors
Heating elements glued to the back of the mirror are used to heat the mirrors. The heating elements of the mirrors are powered by the control module of the corresponding door (driver or passenger)...

Additional driver's view mirror
For Japanese specification only. An additional viewing mirror allows the driver to view «blind» area below the hood level when maneuvering at low speed. The mirror is housed in a plastic housing with...

Control Chart
NOTE: A = rigid connection; D = high speed CAN bus; N = medium speed CAN bus; O = LIN bus. Pos. spare part no Name 1 - Interior rear-view mirror with auto-dimming function 2 - Interior rear-view...

Inspection and verification
CAUTION: Diagnosis by substituting a component from another vehicle is NOT allowed. Substitution of control modules does not guarantee confirmation of the fault and, in addition, may cause additional...

DTC Fault Code Index
NOTE: If a control module or component is suspected and the vehicle continues to be covered by the manufacturer's warranty, refer to the warranty manual before installing a new module/component...

Interior mirror
NOTE: The humidity sensor is installed on some modifications. It is built into the rearview mirror and is not serviced separately. Removing 1. 2. Disconnect the electrical connector. 3. Rotate the...

Mirror glass
Removing 1. Release the exterior mirror glass. 2. Remove glass of an external mirror. Installation 1. When installing, follow the removal procedure in reverse order.

Outside mirror
NOTE: The description of the removal procedure may contain a description of the installation steps. Removing 1. Lower the glass. 2. Disconnect a wire of weight from the accumulator. Refer to...

Exterior mirror motor
NOTE: The description of the removal procedure in this manual may include installation steps. Removing 1. Remove glass of an external mirror. Refer to Procedure: Mirror Glass (501-09 Rear-view...