Car handles, locks, latches Land Rover Freelander 2

Torque Specifications
Description Nm lb-ft Torx Cap Front Door Latch 10 7 Bolt of the internal handle of opening of a latch of a cowl 10 27 Bolts securing the hood latch to the hood latch panel 10 7 Hood safety hook bolts...

Description and principle of operation
NOTE: Left hand drive option shown (LHD); right hand drive variant (RHD) similar. Pos. spare part no Name 1 - Handle and latch right (RH) front door 2 - Dashboard 3 - Right rear door control module 4...

Door latches
Pos. spare part no Name 1 - Internal door lock/unlock button 2 - Internal door handle 3 - Cable for opening a mechanical door lock (only for left front door) 4 - External door lock cable 5 - lock...

Hood latches
Pos. spare part no Name 1 - Hood release handle 2 - Left hood latch 3 - Hood safety hook 4 - Hood soft close switch 5 - Right Hood Latch The hood is locked in the closed position by two latches...

Luggage compartment lifting door latch
Pos. spare part no Name 1 - Luggage compartment lifting door latch 2 - Tailgate lock retainer The liftgate latch is installed at the bottom center of the liftgate inner panel and is an all-electric...

Fuel filler cap mechanism
The filler cap is electrically operated and is locked and unlocked by an actuator and a plastic pin. The actuator is located behind the filler cover body and controls the pin to engage and disengage...

Central locking system controls
The central locking system allows the driver to control the locking and unlocking of vehicle entry points from inside or outside. Manual control of the central locking system is carried out using the...

Control Chart
NOTE: A = rigid connection; F = radio frequency transmission; N = medium speed CAN bus; O = LIN bus. Pos. spare part no Name 1 - Dashboard 2 - CJB 3 - RF receiver 4 - Remote control 5 - launch...

Work principles
Central locking system - manual control The central locking system has two to three manual locking modes, depending on vehicle specification. The locking modes are activated using the central locking...

Inspection and verification
CAUTION: Diagnosis by substituting a component from another vehicle is NOT allowed. Substitution of control modules does not guarantee confirmation of the fault and, in addition, may cause additional...

DTC Fault Code Index
NOTE: If a control module or component is suspected and the vehicle continues to be covered by the manufacturer's warranty, refer to the warranty manual before installing a new module/component...

Table of fault signs
sign Possible reasons Action One of the doors does not open from the outside (but opens from within) Door lock Rope failure Door handle Switch to PINPOINT TEST A . One of the doors does not open from...

Fault localization test
Pinpoint test A: one of the doors does not open from the outside (but opens from within) A1: Check that the door release cable is correctly installed between the lock and the outside door handle...

Latch Receipt Adjustment
1. Make sure adjacent panels are level and evenly spaced. If this condition is not met, follow the adjustment procedure below. 2. Remove the spare wheel cover. 3. Remove an overlay of a threshold of...

Front door latch
Removing 1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications). 2. Remove the electric motor in...

Tailgate latch
Removing 1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications). 2. Remove the electric motor in...

Latch of the raised luggage compartment door
Removing 1. Remove the liftgate trim panel. Refer to Procedure: Liftgate Trim Panel (501-05, Removal and installation). 2. Tightening torque: 25 Nm Installation 1. Replace the elements in reverse...

External front door handle
NOTE: This procedure describes the removal and installation of the left and right front door outside handle. NOTE: If removing the outside handle is being done in conjunction with removing other...

Tailgate outside handle
NOTE: If removing the outside handle is done in conjunction with removing other interior door components, it is recommended that you release the outside door handle and screw cover from inside the...

Door lock cylinder
NOTE: This procedure involves removing and installing the door lock cylinder only. The ignition and door lock cylinders must be replaced as a set. Removing 1. 2. NOTE: Back out the screw just enough...