Dismantling
1. Raise the rear of the vehicle.
WARNING: Do not work under a vehicle that is only supported by a jack. Always install safety props.
2. Loosen the rear section tube clamp nut.
3. Separate from the rear section 2 rubber earrings of the exhaust system suspension bracket.
4. Remove the back section.
Installation
1. Clean the connecting surfaces of the rear section and the middle section of the exhaust system.
2. Install the rear section and hang it on the rubber studs.
3. Tighten the rear section pipe clamp nut to 55 Nm.
4. Remove props and lower the car.
Comments on this article