Dismantling
1. Disconnect "negative" battery terminal.
2. Remove the air cleaning filter.
FUEL SUPPLY OF PETROL ENGINE, REGULATIONS, Air filter, K1.8 engine.
3. Lay out a rag to collect the leaking oil.
4. Turn away 2 bolts of fastening of an epiploon cover to a head of cylinders and remove a cover.
5. Remove the camshaft oil seal using the LRT-12-147 puller with the LRT-12-129 bolt.
6. Dispose of the camshaft oil seal.
Installation
1. Wash the gland seat and camshaft.
2. Put on protective cover LRT-12-203 on the rear end of the camshaft.
3. Install the oil seal using the LRT-12-148A tool.
NOTE: Rear seals are red.
CAUTION: The seals must be installed dry. Do not use LRT-12-148 arbor.
4. Wipe the camshaft oil seal and mating surface.
5. Install the stuffing box cover, screw in the bolts and tighten them to a torque of 25 Nm.
6. Replace the air cleaning filter.
FUEL SUPPLY OF PETROL ENGINE, REGULATIONS, Air filter, K1.8 engine.
7. Attach "negative" battery terminal.
8. Add oil to the engine.
MAINTENANCE, MAINTENANCE, Engine oil and oil filter - K1.8.
Comments on this article