Drain
1. Raise the car on a lift.
2. Remove the lower engine protection shield.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
3. Place a container under the sump drain plug, remove the drain plug and discard the sealing washer. Let the oil drain.
CAUTION: Be careful when draining the oil, it can be very hot.
CAUTION: Avoid prolonged hand skin contact with used engine oil. Used engine oil contains harmful substances that can cause skin cancer or other serious skin conditions.
4. Remove and discard the oil filter.
KV6 ENGINE - MODIFICATION K, Left cylinder head camshafts, Oil filter.
Filling
1. Fill the inside of the new oil filter with fresh engine oil.
2. Lubricate the O-ring of the new filter with fresh engine oil.
3. Screw on the new filter by hand until the sealing surfaces touch, then tighten the filter by half a turn.
4. Clean the drain plug and install a new o-ring.
5. Screw in the drain plug and tighten to 25 Nm.
6. Remove the oil filler cap and add engine oil to the correct level.
FILLING CAPACITIES, LIQUIDS AND OILS, Lubrication system.
7. Replace the oil filler cap.
8. Replace the lower motor shield.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
9. Lower the car.
10. Start the engine. Run the engine at 2500 rpm until the oil pressure warning light goes out.
11. Stop the engine. Check the oil level again.
12. Check for signs of oil leaks.
Comments on this article