Examination
1. Disconnect "negative" battery terminal.
2. Remove the bottom motor shield.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
3. Turn the steering all the way to the right.
4. Turn away 3 bolts and remove the right protective screen.
5. Check the condition of the drive belt. If signs of wear or delamination are found, replace the drive belt with a new one.
Adjustment
1. Loosen the clamp bolt and swivel bolt of the compressor drive belt tensioner.
2. Apply a counterclockwise torque to the tensioner hex. For a used belt, the torque value should be 36 Nm, and for a new one - 47 Nm.
3. Tighten the clamping bolt to 24 Nm.
4. Tighten the pivot bolt to 24 Nm.
5. Install the protective screen and tighten its fastening bolts with a torque of 10 Nm.
6. Replace the lower motor shield.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
7. Attach "negative" battery terminal.
Dismantling
1. Disconnect "negative" battery terminal.
2. Remove the implement drive belt.
ENGINE START AND BATTERY CHARGING SYSTEM, REPAIR WORK, Attachment drive belt - Td4 engine.
3. Loosen the clamp bolt and swivel bolt of the compressor drive belt tensioner.
4. Remove the compressor drive belt.
Installation
1. Make sure the drive belt, compressor and crankshaft pulleys, and tensioner pulley are clean.
2. Install the compressor drive belt.
3. Adjust the tension of the compressor drive belt.
AIR CONDITIONING SYSTEM, Air conditioning compressor drive belt - for models with Td4 engine, Air conditioning compressor drive belt - for models with Td4 engine.
4. Install the implement drive belt.
ENGINE START AND BATTERY CHARGING SYSTEM, REPAIR WORK, Attachment drive belt - Td4 engine.
5. Attach "negative" battery terminal.
Comments on this article