Sleeve of a back support of a case of differential (Freelander 1)

Dismantling

1. Raise the rear of the vehicle.

WARNING: Do not work under a vehicle that is only supported by a jack. Always install safety props.

2. Install the LRT-51-013 centering tool to set the differential position.



3. Turn out a bolt of fastening of a support of a case of differential to a subframe.

4. Turn out 2 bolts of fastening of differential to a support.

5. Remove the support.

Installation

1. Install the differential housing support.

2. Screw in the bolts securing the support to the differential housing and tighten them to a torque of 65 Nm.

3. Screw in the bolt securing the support to the subframe and tighten it to 120 Nm.

4. Remove the LRT-51-013 snap.

5. Remove props and lower the car.