Dismantling
1. Raise the front of the car.
WARNING: Do not work under a vehicle that is only supported by a jack. Always install safety props.
2. Turn away 4 bolts of fastening of rubber-metal supports of a bar of the stabilizer to a stretcher. Don't throw away the supports.
3. Remove pillows of a bar of the stabilizer of cross-section stability.
Installation
1. Clean the stabilizer bar, bar supports and their seating surfaces.
2. Install the anti-roll bar pads.
3. Install the rubber-metal supports of the stabilizer bar, screw the bolts of the supports and tighten them with a torque of 23 Nm.
4. Remove props and lower the car.
Comments on this article