Car body sealing and corrosion Land Rover Freelander 1

Body sealing materials
1 - Between panels - bolted connection 2 - Between panel edges - bolted connection 3 - Between panels - spot welding connection 4 - Between the edges of the panels - spot welding connection 5 -...

Sealant application equipment
3M Automotive Trades Group 3M UK Plc 3M House PO Box 1 Market Place Bracknell Berks. RG121JU ((01344) 858611 Cooper Pegler Burgess Hill Sussex RH159LA ((014 446) 42526 SATA Spray Equipment Minden...

Body cavity treatment equipment and treatment methods
1 - Air inlet 2 - Spray pattern adjustment 3 - Tank (1 liter capacity). Maximum pressure 9.7 bar (9.84 kg/sq.cm) 4 - Gun fitting 5 - Nozzle fitting 6 - Flexible tip 7 - Rigid tip with narrow cone...

Protective wax cavities and openings — 3-door body
All places located symmetrically shown in the figure are also subject to processing. Symbols for the figure "Protective waxing of cavities and spray holes - 3-door body version". 1 - Hole for...

Door sill protection holes — 5-door body
1 - Hole for injection into the inner cavity of the threshold 2 - Rear hole for injection into the inner cavity of the threshold 3 - Front hole for injection into the inner cavity of the threshold

Protective waxing of cavities and openings — 5-door body
All places located symmetrically shown in the figure are also subject to processing. 1 - Hole for injection into the space between the outer panel and the back door reinforcement panel 2 - The inner...

Anti-corrosion treatment
Details of anti-corrosion treatment are discussed in the information below. Factory processing During the manufacturing process, the car body is treated with the following anti-corrosion materials....

Underbody areas treated with sealing materials
Underbody sealing materials The surface of the bottom and the outer surfaces of the thresholds are treated with a bottom sealant Plastisol PVC. This material is not suitable for reapplication. During...

Adhesive materials for load-bearing body elements
Adhesive mastic, applied directly to the metal, is applied to the critical joints of the parts during the factory assembly of the body. In this case, high-temperature deposition of a material based...

Seam sealing materials
During the factory assembly of the body, a PVC-based sealing coating is applied in a heated state to some welding points. This material is not intended for use in body repair and must therefore be...

Acoustic insulation with foam material
The picture shows the 3-door version of the body. The figure shows the 5-door version of the body. Expandable foam seals are used in various body cavities to improve vehicle performance. These seals...

Water intrusion into the body
When water enters the body, always use a logical approach to the problem of fixing a leak, using experience, knowledge and intuition. You can't make a decision based on what you see, like when you...

Preparing the panel for painting
General information Replacement body parts have an initial cathophoresis primer coating as part of the panel protection that complies with the general warranty against body corrosion. DO NOT remove...

Car preparation for painting
To restore the paintwork, use the following operations. 1. Treat the outer and inner surfaces of the weld with the recommended protective coating. Application equipment. 2. Repair damaged underbody...