Engine lower shield (Freelander 1)

Dismantling

1. Raise the front of the car.

WARNING: Do not work on or under a vehicle that is only jacked up. Always install safety props.

2. Remove the 2 screws securing the bumper to the brackets of the lower engine protection shield.

3. Turn away 4 screws of fastening of a fender liner to a bumper if it is installed.

4. Loosen the 2 screws securing the rear of the lower motor guard.

5. Turn away 6 screws of fastening of the bottom board of protection of a body to a frame.

6. Remove the lower engine protection shield.

Installation

1. Attach the lower motor shield.

2. Screw in the bolts securing the lower engine protection shield to the frame and tighten them to a torque of 45 Nm.

3. Screw in the bolts securing the rear of the lower engine protection shield and tighten them to a torque of 8 Nm.

4. Wrap and tighten the screws securing the fender liner to the bumper, if installed.

5. Wrap and tighten the screws securing the bumper to the brackets.

6. Remove props and lower the car.