Car gearbox Land Rover Discovery 3

Specification of automatic box 4.0L
Lubricants Paragraph Specifications * Recommended lubricants ATF Shell M13754 + Torque converter neck Molybdenum disulphide grease meeting FB180 specifications WARNING: * Use only prescribed...

Specification of automatic box 4.4L
Lubricants Position Specification * Recommended lubricants Shell M13754. Part No. Land Rover TYK500050 + Torque converter neck Molybdenum disulphide grease meeting FB180 specification CAUTION: * Do...

Specification of automatic box 2.7L
Lubricants Position Specification * Recommended lubricants Shell M13754 + Torque converter neck Molybdenum disulphide grease meeting FB180 specification CAUTION: * Do not use other lubricant than...

Diagnosis and check of automatic transmission 4.0L
Review This section is intended to provide mechanics with methods for diagnosing problems with transmission components instead of replacing the entire assembly. However, there are a number of...

Removal and installation of an automatic box 4.0L
Special tool Torque converter seal installer 308-246 Torque converter support handles 307-497 (LRT-44-010) Removing 1. WARNING: It is forbidden to carry out work on a vehicle supported only by a...

Removal and installation of an automatic box 2.7L
Special tool Adapter for key 303-1069 Removing 1. Disconnect a wire of weight from the storage battery. For more information refer to Specification. 2. WARNING: It is forbidden to carry out work on a...

Specification of automatic transmission controls
Specification 4.0L Paragraph Specifications Type With cable-actuated crank arm on the gearbox side from the shift mechanism and manual release from the park position 'P' in the event of an electrical...

2.7L mechanical box specification
Sealants Name Land Rover Part No Adapter shaft bolt with hexagon socket head STC 50553 Lubricant Name Specifications * Recommended lubricants Burmah/Castrol MTF BOT 338 WARNING: * Use only prescribed...

Removing the manual transmission 2.7L
Removing 1. Put the car on a lift. 2. Disconnect the wire "masses" from the battery. 3. Remove the switch of system of dynamic stabilization. For more information, refer to Switch for optimizing...

Installation of a manual transmission 2.7L
Installation 1. Place the gearbox on a gearbox jack. 2. CAUTION: Make sure the box is not skewed. CAUTION: Before installing the gearbox, check that the clutch assembly is not damaged. NOTE: Do not...