Rear exhaust pipe 4.0L (Discovery 3)

Special tool

Exhaust cutter 100-051 (LRT-99-027)

Removing

1.

WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Always place secure supports under the vehicle.

Raise and place the vehicle on stands.

2. Remove the exhaust pipe.

• Using tool 100-051, cut off the exhaust pipe at the location indicated by the dimple in the exhaust pipe.
• Disconnect from the outboard support of the exhaust system.

Installation

1.

NOTE: Do not tighten clamp at this stage.

Install the exhaust pipe.

• Clear the elements.
• Install clamp.

2. Position the exhaust pipe and tighten the clamp to 55 Nm.