Removing
1. If it is necessary to replace the central switching unit (CJB), connect the car to T4.
2. Remove the glove box. For more information refer to Glove Compartment (76.52.03)
3. Remove the decorative panel from the passenger side.
- Release the clamp.
- Remove two screws.
- Disconnect the electrical connector.
4. Remove the CJB.
- Loosen 2 nuts.
- Disconnect 6 electrical connectors.
Installation
1. Install CJB.
- Connect electrical connectors.
- Tighten nuts (tightening torque 10 Nm).
- Connect the electrical connector.
- Lock the clamp.
4. Initialize the new CJB with T4.
Comments on this article