Instruments and control lamps of the car Land Rover Discovery 3

The device and description of the instrument panel
High level instrument panel NOTE: The model of the dashboard of a car with a gasoline engine and right-hand steering for the UK market is shown Item name Spare part number Description 1 - Control...

Control lamps of a board of devices
Pilot lamps Control lamps are located in different parts of the instrument panel. Pilot lamps can be divided into two groups: self-controlled and externally controlled. The activation of the...

Analog Gauges Instrument
The instrument panel contains the following analogue instruments: Speedometer Tachometer Fuel gauge Coolant temperature gauge The speedometer, tachometer, fuel gauge and coolant temperature gauge are...

Diagnostics and check of the instrument panel
Review Data to the instrument panel from modules of other subsystems are fed in the form of CAN·messages. The instrument panel identifies the signals and displays the corresponding message in the...

Removal and installation of the instrument panel
Removing 1. Fully extend the steering column to gain access. 2. Remove the steering wheel. For more information refer to Steering wheel (57.61.01) 3. Remove the top casing of a steering column....

Device and description of the sound signal
Item name Spare part number Description 1 - Steering wheel horn switches 2 - Central distribution block (CJB) 3 - Fuse 12 4 - Low tone beep 5 - high-pitched horn General information The car is...

Information and message center
Information and message displays Item name Spare part number Description 1 - Terrain Response™ Icons (if applicable) 2 - Message display 3 - Message Center LCD 4 - Odometer display 5 - Unit display...

Information display
The information display is a liquid crystal display (LCD display), located at the bottom right of the instrument panel. The visible area of the LCD is 43x20mm and is divided into seven segments. When...

User settings and on-board computer
User Settings User settings allow the driver to adjust certain vehicle settings to change the functionality of selected vehicle functions. User settings are available only on models with upgraded...

Tire pressure warning module
Removing NOTE: If the tire pressure monitoring module is replaced, the T4 must be connected and the necessary procedures performed before the battery is disconnected. 1. Disconnect a wire of weight...

Device and description of parking assistance
Location of elements of the parking assistance system Item name Spare part number Description 1 - Front sensors 2 - Parking assistance speaker 3 - 3 rear sensors 4 - Parking assistance module 5 -...

Obstacle Distance Calculation
On vehicles equipped with only rear sensors, the parking assistance system is automatically activated when the ignition key is in position II and reverse gear is engaged. The parking assistance...

Diagnosis and verification of parking assistance
Inspection and verification 1. Make sure the customer's complaint is valid. 2. Visually inspect for obvious mechanical and electrical problems. 3. Make sure that there is no dirt on the surface of...

Parking assistance speaker
Removing 1. Remove the bottom panel of a back rack. For more information, please refer to the lower pillar trim panel (76.13.34) 2. Remove the luggage compartment trim support bracket. Remove 2...

Rear interior parking aid sensor
Removing 1. Remove the rear bumper cover. For more information, please refer to 2. Remove the parking aid sensor. Release two clamps. 3. Remove the parking aid sensor trim panel. Release the three...

Rear Outside Parking Assist Sensor
Removing 1. WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always support the vehicle with jack stands. Raise and support the vehicle. 2. Remove the parking aid...

Parking Assist Module
Removing 1. Remove the bottom panel of a back rack. For more information, refer to Lower Pillar Trim Panel (76.13.34) 2. Remove the parking aid module. Disconnect 3 electrical connectors. Loosen 2...

Front interior parking aid sensor
Removing 1. Remove the front bumper trim. For more information refer to Front Bumper (76.22.49) 2. Remove the parking aid sensor. Release from two clamps. 3. Remove the parking aid sensor trim panel....

Front Outside Parking Assist Sensor
Removing 1. Remove the front bumper cover. For more information refer to Front Bumper (76.22.49) 2. Remove the parking aid sensor. Release two clamps. 3. Remove the parking aid sensor trim panel....