Vehicle climate control system Land Rover Discovery 3

Specification
General specification Type Description Heating, ventilation and air conditioning unit Front module - manual version Front module - version with temperature control module (ATC) Rear module Centered...

Removal and installation of the storage chamber
Removing 1. Remove pillar moldings "A". For more information refer to Left pillar molding «A» 2. Remove the windshield wiper arms. For more information, refer to Front Wiper Arm (84.15.02) 3. Release...
There is 1 a comment

Removal and installation of the cabin filter
Removing 1. Open the glove box lid to the service position. Release the locks on the glove box lid. 2. Remove the dust filter housing cover. 3. Remove the dust filter. Installation 1. Replace the...

Device and description of heating and ventilation
Location of elements NOTE: The figure shows RHD (left hand drive vehicle) shown, LHD (right hand drive vehicle) has a similar device. Item name Spare part number Description 1 - Fan relay 2 - Fan...

Diagnostics and testing of heating and ventilation
Review The heating and ventilation system has a fairly simple design that does not require any specialized methods to perform diagnostics. Follow the visual inspection procedure below and refer to...

Electric motor of the blowing fan
Removing 1. Remove the glove box. For more information refer to Glove Compartment (76.52.03) 2. Remove the decorative panel from the passenger side. Release the clamp. Remove two screws. Disconnect...

Air conditioning specification
Lubricant Position Specification compressor oil Oil Denso ND-8 PAG Total system capacity: front of the car 130 cm 3 (4.5 fl oz) Rear of the car 170 cm 3 (5.9 fl. ounces) When replacing a system part,...

Diagnostics and testing of air conditioning
Inspection and verification 1. Make sure the customer's complaint is valid. 2. Visually inspect for obvious mechanical and electrical problems. Mechanical factors Electrical Factors Auxiliary drive...

Removal and installation of the dehumidifier receiver
Removing NOTE: The filter drier of the air conditioning system must be replaced in the following case: Dirt is present in the air conditioning piping (for example, causing the compressor to seize)....

Removal and installation of the evaporator core
Removing 1. Evacuate the air conditioning system. For more information, refer to Refrigerant Recovery, Vacuuming and Charging the Air Conditioning System (A/C) (82.30.02) 2. WARNING: It is forbidden...

Device and description of climate control elements
Location of elements NOTE: The picture shows a car with RHD (left hand drive), vehicle with LHD (right hand drive) has a similar device. Item name Spare part number Description 1 - Dirt sensor (Japan...

Solar intensity sensor
Removing 1. Remove the speaker grille from the top of the control panel. Release 4 clips. 2. Remove the sunlight sensor. Release 2 clips. Disconnect the plug connector. Installation 1. Replace the...

Cabin temperature sensor
Removing 1. Fully extend the steering column for easy access. 2. Remove the control panel access panel. Release 2 clips. 3. Remove the upper casing of the steering column. Release 6 clips. 4. Remove...

Outdoor temperature sensor
Removing 1. Remove the grille. For more information refer to Radiator Grille (76.55.03) 2. Remove the ambient temperature sensor. Disconnect the plug connector. Release the clamp. Installation 1....

Complete climate controls
Removing 1. Remove the control panel console. For more information refer to Dashboard Console (76.25.03) 2. Remove the climate control unit (climate control unit). Remove the 4 Tox screws. Disconnect...