Car steering column Land Rover Discovery 3

Location of components and parts of the steering gear
Item name Spare part number Description 1 - Steering gear 2 - Steering gear cover 3 - thrust 4 - Lock-nut 5 - Rod end 6 - ball joint 7 - Self-locking nut General information The steering drive...

Steering gear cover
Removing 1. Remove the tie rod end. For more information refer to Rod End (57.55.07) 2. NOTE: Note the position of the part. Loosen the locknut. 3. Remove the steering gear cover. Loosen 2 clamps....

Steering rod tip
Special tool Ball joint puller 205-754 (LRT-54-027) Removing 1. WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always support the vehicle with jack stands. Raise...

Transverse steering rod
Special tool Ball joint puller 205-754 (LRT-54-027) Removing 1. WARNING: Do not work on or under the vehicle if it is only supported by a jack. Always place secure supports under the vehicle. Raise...

Steering column specification
General specifications Name Specification Type Consists of two parts, articulated type, with fastening to the steering rack through the articulated coupling; has an energy-absorbing mechanism with a...

The location of the elements of the steering column
Item name Spare part number Description 1 Screw (3 pcs.) 2 Steering angle sensor 3 Upper part of the steering column - mechanical drive 4 Upper part of the steering column - electric drive 5 Casing...

The upper part of the steering column with a mechanical adjustment unit
Item name Spare part number Description A - Crash compression stroke is 120.00 mm 1 - Mounting holes 2 - Top brace 3 - Screw 4 - fixing hook 5 - U-bracket 6 - Steering wheel slots 7 - Complete lock 8...

Upper part of the steering column with electric adjustment unit
Item name Spare part number Description A - Crash compression stroke is 90.00mm 1 - mounting hole 2 - Top brace 3 - fixing hook 4 - Steering wheel slots 5 - External profile 6 - Complete lock 7 -...

Intermediate shaft
Item name Spare part number Description 1 - Centering groove 2 - mounting hole 3 - Cuff 4 - Load limiter pins 5 - Cam Bolt 6 - Self-locking nut 7 retaining spring CAUTION: When handling the...

Lower telescopic shaft
Item name Spare part number Description 1 - Torx bolt 2 - U-Fork 3 - Cardan joint 4 - Flexible connection 5 - pin shaft 6 - Nest shaft 7 - heat shield 8 - Bolt 9 plastic sleeve The lower telescoping...

Steering column lock
Item name Spare part number Description 1 - lock cylinder 2 - Steering column lock assy 3 - Locking bolt 4 - ignition switch 5 - mounting hole 6 - Label 7 - Lock drive 8 - Cylinder release hole 9 -...

Steering wheel heating
The driver can control the steering wheel heating function using the switch on the steering wheel. Depending on the equipment variant, the switch is either a dual function switch or a separate...

Steering column shaft
Removing 1. Disconnect the wire "masses" from the battery. For more information refer to Specification. 2. Remove the decorative panel from the driver's side. Release the clamp. Remove two screws....

Steering column lower shaft
Removing 1. WARNING: Do not work on or under a vehicle supported only by a jack. Be sure to support the car with special stands. Raise and support the vehicle. 2. Open the hood. 3. CAUTION: Make sure...

Removal and installation of a steering column
Removing All cars 1. To gain access, fully extend the steering column. 2. Remove the steering wheel. For more information refer to Steering wheel (57.61.01) 3. Remove the driver's side air deflector...

Removal and installation of a steering wheel
Removing 1. Remove the driver's airbag module. For more information, refer to Driver Airbag Module (76.74.01) 2. CAUTION: If the steering wheel alignment marks were not aligned prior to removing the...

Multifunction steering column switch
Item name Spare part number Description 1 - The switch of indexes of turn assy 2 - Screw (2 pcs.) 3 - Frame 4 - Screw (2 pcs.) 5 - Wiper control switch assy 6 - coil spring 7 - Screw (4 things.) The...

The switch of indexes of turn assy
Item name Spare part number Description 1 - high beam 2 - Right direction indicator 3 - High beam signaling 4 - Left turn signal 5 - Computer function button The turn signal switch assembly is...

Wiper control switch assy
Item name Spare part number Description 1 - Intermittent operation 2 - Continuous operation at low speed 3 - Continuous high speed operation A - Single cleaning B - Rear window cleaning/washing C -...

Egnition lock
Item name Spare part number Description 1 - lock cylinder 2 - Steering column lock 3 - Locking tab 4 - ignition switch 5 - Wiring harness connector 6 - Drive shaft mount 7 - Key lock solenoid The...

Steering column lock and ignition switch housing
Removing ATTENTION: If it is necessary to remove the lock cylinder together with the switch from the ignition lock, make sure that the assembly shaft DOES NOT TURN. Failure to do so will result in...

Left multifunction steering column switch
Removing 1. To gain access, fully extend the steering column. 2. Remove the upper casing of the steering column. Release 6 clips. 3. Remove the lower casing of a steering column. Remove 3 Torx...

Ignition switch
Removing 1. For better access, pull the steering column fully forward. 2. Remove the upper casing of the steering column. Release 4 clamps. 3. Remove the lower casing of a steering column. Remove 3...

Right multifunction steering column switch
Removing 1. To gain access, fully extend the steering column. 2. Remove the upper casing of the steering column. Release 6 clips. 3. Remove the lower casing of a steering column. Remove 3 Torx...