Exit air purge program (Discovery 3)

1. Ignition on, engine off.

2. Ignition off.

3. Press and release the lift switch.

4. Press and release the lower switch.

5. Ignition on, engine off.

6. Ignition on, engine running.

7. Press and release the lift switch twice.

8. Press and release the lower switch twice.

9. Press and release the lift switch.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Dynamic suspension specification
Location of Dynamic Suspension Components
Pneumatic scheme
Air suspension operating modes
Special air suspension modes
Air suspension control unit
Air suspension diagnostics
Air suspension switch
Valve blocks front and rear axles
Receiver valve block
Compressor block
Airbox receiver
Height sensors
Silencer and air intake filter
Air highway
Air suspension control scheme
Inspection and verification
Table of fault signs
DTC Fault Code Index

Current article

Exit air purge program

Releasing and raising pressure in the air suspension system
Air leaks
Ride height adjustment
Air suspension cylinder
Block of solenoid valves of air suspension tank
Rear air suspension solenoid valve block
Front air suspension solenoid valve block
Air suspension air filter
Air suspension silencer
Suspension height sensor
Air suspension pressure sensor
Rear shock absorber with air spring
Rear air shock absorber
Air suspension compressor
Air suspension control module
Air Suspension Compressor Dryer
Front shock absorber with air spring
Front air shock absorber

Comments on this article

No comments yet

Discovery 3