Air suspension control module (Discovery 3)

Removing

1. Driver's side: Remove the front door trim panel. For more information refer to Front Doorway Trim Panel (76.13.27)

2. Remove the cover plate.

• Release the clamp.
• Remove two screws.
• Disconnect the electrical connector.

3. Remove the electronic air suspension control unit.

• Disconnect 4 electrical connectors.
• Turn out a bolt.
• Release 2 clips.

Installation

1. Install the electronic air suspension control unit.

• Secure with clips.
• Connect electrical connectors.
• tighten bolt (tightening torque 9 Nm).

2. Install the cover plate.

• Connect the electrical connector.
• Lock the clamp.
• Tighten the screws.

3. Install the front door trim panel. For more information refer to Front Doorway Trim Panel (76.13.27)

4. Initiate the new electronic unit with T4.