Sunroof and car bumpers Land Rover Discovery 3

The device and technical description of the sunroof
Elements of the design of the hatch panel Item name Spare part number Description 1 - Glass panel assembly 2 - Glass panel seal 3 - Frame assembly 4 - sunblind 5 - electric motor 6 - control module 7...

Sunroof operation
Hatch work The sunroof can only be operated if the ignition switch is in position I or II. In addition, the sunroof operates for 40 seconds after the ignition is turned off, provided that the...

Sunroof Control Diagram
NOTE: A = wired; B = local LIN bus Item name Spare part number Description 1 - Fuse 11 2 - Egnition lock 3 - Fuse 20 4 - Central distribution block (CJB). 5 - sunroof controller 6 - sunroof motor 7 -...

Diagnosis and check of the sunroof
Inspection and verification 1. Make sure the customer's complaint is valid. 2. Visually inspect for obvious mechanical and electrical problems. Mechanical factors Electrical Factors Glass panel...

Sunroof alignment
1. With the hatch panel closed, adjust the position of the glass in relation to the hatch. Glass should be located in the center of the hatch opening. The position of the hatch in relation to the...

Removal and installation of the sunroof
Removing 1. Remove an upholstery of a roof. For more information, refer to Headlining (76.64.15) 2. Disconnect the 4 drain hoses from the sunroof panel. 3. Disconnect the sunroof motor electrical...

Sunroof module
Removing 1. Remove the rear upper console. Carefully release the 9 clips. Disconnect the two electrical connectors. 2. Remove the sunroof module. Slide the module to the left to release it from the...

Sunroof glass
Removing 1. Open the sunroof. 2. Tilt sunroof. 3. Remove glass of the hatch. Remove 3 Torx head screws. Repeat the above procedure on the other side. Installation 1. Install the sunroof glass....

Electric motor of the sunroof drive
Removing 1. Remove both top panels of finishing of a forward rack of a body. For more information refer to 'A' Pillar Trim Panel (76.13.26) 2. Remove both top panels of finishing of an average rack...

Rear bumper cover
Removing All cars WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Always place secure supports under the vehicle. Raise the car and place it on stands. 2. Remove...

Front bumper cover
Removing 1. WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Always place secure supports under the vehicle. Raise the car and place it on stands. 2. Remove the wing...

Removal and installation of a forward bumper
Removing All cars 1. Remove the front bumper trim. For more information refer to Front Bumper Cover (76.22.72) Vehicles with dynamic suspension 2. Disconnect the front air suspension valve block from...