Front seat belt buckle (Discovery 3)

Removing

WARNING: Before carrying out any work on the SRS system, read the related information carefully.

CAUTION: Always disconnect both wires from the battery before working on the SRS system. Disconnect the cable first "masses". Never connect the battery with reverse polarity.

1. Disconnect the wire "masses" from the battery.

For more information refer to Specification.

2. Secure the SRS system.

For more information, refer to Standard Techniques Used in a Service Station.

3. Remove the front seat.

For more information refer to Front Seat (78.10.44/99)

4. Remove the seat back hinge cover. Remove 2 screws.



5. Remove the front seat belt buckle.

• Remove the Torx head bolt.
• Disconnect the two electrical connectors.
• Release the wiring harness.

Installation

1. Install the front seat belt buckle.

• Tighten Torx Head Bolt (tightening torque 40 Nm).
• Connect electrical connectors.
• Connect the wiring harness.

2. Install the seatback hinge cover. Tighten the screws.

3. Install the front seat.

For more information refer to Front Seat (78.10.44/99)

4. Connect the wire "masses" to the battery.