Removing
CAUTION: To simplify the installation procedure, remember the wiring diagram and the location of the wire harness clamps.
1. Refer to the procedure: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General Procedures).
2.
3.
CAUTION: To avoid damaging the components, use an extra wrench when loosening and tightening the terminals.
4.
5. Refer to Procedure: Radiator Grille (501-08 Exterior finish, Removal and installation).
6.
WARNING: Place jack stands under the vehicle.
Raise and support the vehicle.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
WARNING: This operation is performed with an assistant.
Installation
1.
WARNING: This operation is performed with an assistant.
Install winch.
2. Tighten the bolts to 40 Nm.
3. Install the winch hook.
4.
Caveats:
- Route the cables according to the diagram you made when removing.
- Install the clips in the places marked during removal.
Connect the power and ground cables of the winch.
5. Tighten to 25 Nm.
6. Connect the winch power cable to the battery.
7.
CAUTION: To avoid damaging the components, use an extra wrench when loosening and tightening the terminals.
Tighten to 7.3 Nm.
8.
9. Refer to Procedure: Radiator Grille (501-08 Exterior finish, Removal and installation).
10. Refer to the procedure: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General Procedures).
Comments on this article