Heating and ventilation system Land Rover Defender 90/110/130

Specifications
Lubricants, working fluids and sealants Element Specifications Sealant - between motor and fan housing WSE-M4G323-A4 Torque Specifications Description Nm lb-ft heater fan 15 11 Radiator housing for...

Complete climate controls
Removing 1. Remove the control panel console. For more information, refer to the chapter: Dashboard Console (501-12 Instrument panel and console, Removal and installation). 2. Remove the climate...

Cabin blower motor resistor
Removing 1. Disconnect the electrical connector. 2. Remove blower motor resistor. Remove two screws. Installation 1. Replace the elements in reverse order.

Fan — removal and installation
Removing 1. Remove the intake duct. For more information, refer to the chapter: Air Inlet Pipe (412-01 Air distribution and purification, Removal and installation). 2. CAUTION: Plug all openings. Use...

Heater housing — removal and installation
Removing 1. Disconnect the wire "masses" from the battery. For more information, see the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General...

Heater core — removal and installation
Removing 1. Disconnect the wire "masses" from the battery. For more information, see the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General...

Heater core and evaporator core housing
Removing 1. Disconnect the wire "masses" from the battery. For more information, see the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General...

Heater control valve
Removing 1. Remove the hood switch. Disconnect the hood switch electrical connector. 2. NOTE: Mark the installation position of the cable before removing it. Disconnect the heater control cable....

Electric motor of the cooling system fan
Materials Name Specification Silicone sealant WSE-M4G323-A4 Removing NOTE: Shown for left hand drive, same for right hand drive. 1. Disconnect the coolant expansion tank from the radiator pipe. 2....

Air distribution and purification
Location of elements NOTE: Left hand drive vehicle shown (LHD), a similar device has a car with right-hand drive (RHD). Pos. spare part no Name 1 - left (LH) window blow hole 2 - Left LH windshield...

Air intake inlet pipe
Removing 1. Remove the vent grille. Remove 7 screws. 2. Empty the air intake. Remove two screws. 3. Remove the wing support bracket. Turn out two bolts. 4. Disconnect the electrical connector of the...

Dashboard shutters
Removing 1. Use a lever to pry off each lower corner and disconnect the cold air ducts from the instrument panel deflectors. 2. Turn out the screw of fastening of a reverse side of deflectors to the...