Rear drive axle of the car Land Rover Defender 90/110/130

Rear Drive Axle / Differential Specifications
Rear axle Type Spiral bevel gears, fully floating shafts Gear ratio 3,54:1 Sealants Position Land Rover Part No Rear axle differential box STC 3811 Ring gear to differential box bolts STC 50552...

Diagnostics and checks of the rear axle
Oil leaks External grease leakage from the hub seals can be caused by a defective internal seal. For example, if the seals that separate the differential from the hubs are faulty and the vehicle is...

Description and principle of operation of the rear axle
Description Welded steel rear axle housing contains a differential (with bevel gears with helical curved teeth), which is set offset to the right of the vehicle centerline. The differential, using...

Differential box 90
Car repair 1. Using a suitable container, drain the oil from the axle. 2. Mark the differential and driveshaft flanges to facilitate assembly. 3. Turn out four bolts and disconnect cardan shaft from...

Bridge assembly — removal and installation
Removing WARNING: Removal and installation of the bridge requires an additional two people to support the bridge when it is lowered or moved. 1. Drain the brake fluid from the brake system. 2. Place...

Dismantling and assembly of the bridge 110/130
Disassembly 1. NOTE: *This procedure is applicable to 110 and 130 models starting with the following VIN: 110 without ABS - 638164 110 Heavy Duty and 130 without ABS - 638224 110 Heavy Duty and 130...

Dismantling and assembly of the bridge 90/110
Disassembly 1. NOTE: *This procedure only applies to 110 models up to and including the following VINs: 110 without ABS -638163 110sABS -638248 Remove the differential assembly. 2. Mount the...

Short shaft guide bearing 110/130
Removing Pos. spare part no Name 1. - Short axle shaft 2. - Bolt of fastening of a short shaft of a semiaxis to a crankcase of the leading bridge 3. - Mudguard 4. - Short axle shaft 5. - Gasket,...

Guide bearing short shaft 90
Removing Pos. spare part no Name 1. - Bolt of fastening of a short shaft of a semiaxis to a crankcase of the leading bridge 2. - Mudguard 3. - Short axle shaft 4. - Gasket, short axle shaft 5. -...

Pinion seal 110/130
Removing NOTE: *This procedure is applicable to 110 and 130 models starting with the following VIN: 110 without ABS - 638164 110 with ABS - 638249 110 Heavy Duty and 130 without ABS - 638224 110...

Drive gear seal 90
Removing 1. Raise the back of the car. WARNING: Do not work under a vehicle supported only by a jack. Always support the vehicle with jack stands. 2. Put control marks on the flanges of the propeller...