Removing
1.
WARNING: Install secure supports.
Raise the front of the car.
2. Remove the front wheel.
3. Place a jack under the bridge.
4. Turn out 6 screws of fastening of the top cover of the shock-absorber to a mudguard of engine compartment and remove a cover.
5. Unscrew the nut securing the shock absorber to the upper support bracket and remove the rubber bushing and 2 washers.
6. Turn away 4 nuts of fastening of the shock-absorber to a basic arm and remove washers.
7. Remove the shock absorber top cover.
8. Turn out 4 screws and 3 hairpins of fastening of a mudguard of a wing to a mudguard of engine compartment. Remove the wing mudguard.
Installation
1. Install the fender mudguard and secure it with screws and studs.
2. Install shock absorber support bracket and tighten nuts.
3. Install the shock absorber to the support bracket, install the rubber bushing and washers, and tighten the nut.
4. Install the shock absorber cover on the engine compartment mudguard and secure with screws.
5. Install the wheel.
6. Remove the supports and lower the car.
Comments on this article