Car exterior trim Land Rover Defender 90/110/130

Outer rollover protection beam
Removing 1. Remove the Torx bolts on both sides securing the top of the rollover protection beam from the roof beam. 2. Using assistance to support the roll-over protection beam on the windshield,...

Rear folding footrest
Removing 1. Remove the 2 bolts securing the footrest to the chassis, remove the footrest and spacers. Installation 1. Position footrest, install spacers and tighten bolts.

Radiator grille — removal and installation
Removing 1. Disconnect the wire "masses" from the battery. For more information, see the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General...

Traction hitch — removal and installation
Removing 1. Turn out four bolts of fastening of the stabilizer of cross-section stability to back section of the lower protection. 2. Remove the 6 bolts securing the rear section of the bottom guard...

Hood — removal and installation
Removing 1. Remove the hood. With assistance, remove the hood upwards. Installation 1. Replace the elements in reverse order. Make sure the hood rails are aligned with the hinge bracket.

Wing — removal and installation
Removing 1. Remove the wing mudguard. For more information, please refer to the chapter: Fender Mudguard (501-02 Front body panels, Removal and installation). 2. Remove the grille. For more...

Mudguard wing — removal and installation
Removing 1. WARNING: Install secure supports. Raise the front of the car. 2. Remove the front wheel. 3. Place a jack under the bridge. 4. Turn out 6 screws of fastening of the top cover of the...

Body and Frame — Vehicle Details and Tolerance Checks
Chassis The chassis on all variants of the Defender is made of box-section profiles and has a frame structure. The structural material is steel 2 mm thick, treated with zinc phosphate and having a...

Corrosion protection
Connection types Pos. spare no Name 1. parts Between bolted panels 2. - Between the edges of bolted panels 3. - Between panels joined by spot welding 4. - Between the edges of panels joined by spot...

Water leaks — diagnostics and checks
Inspection and verification 1. Make sure the customer's complaint is valid. 2. Perform a visual inspection for obvious mechanical or electrical damage. 3. If a clear cause for an observed or...